Cable Adapters

LINE 6 CABLE ADAPTER - (2.1mm to 2.5mm, Reverse polarity)

• If you use a DL4 or any other LINE6 modelling pedal in this range the LINE 6 Adapter will allow you to run it from your Generator. 
• All you need to do is put this adapter on the end of one of your Distributor cables and plug it in to your Line 6 modelling pedal or Digitech RP100 series pedal and your good to go.

*WARNING - THE LINE 6 CABLE ADAPTOR WILL NOT WORK WITH THE LINE 6 HX EFFECTS, AS THE UNIT IS CENTER NEGATIVE. Please select the 2.1mm to 2.5mm adapter for this pedal*

2. MINI JACK CABLE ADAPTOR

• If you use a pedal that requires a Mini Jack d.c. input then this is the answer. 
• Just pop it on the end of one of the Distributor cables if you're using a TS-808, or on the end of one of our adapters if you need it for something a bit special. 
• If you are using an old 18V Electric Mistress for example, just put it on the end of one of our Doubler 9-18V adapters and plug straight into the Mistress.

3. REVERSE POLARTITY 2.1mm CABLE ADAPTER

• A simple 2.1mm reverse polarity adapter, so if it goes in centre negative, it comes out centre positive.
• Useful with a Virtual Battery to power some positive ground effects that need to be isolated.
• Due to problems with supplier, adaptor may appear different in appearance from the item pictured above.

4. 2.1mm to 2.5mm CABLE ADAPTER

Some pedals use a 2.5mm d.c. input opposed to a normal BOSS style 2.1mm. 

Please see Key Features